2005 Buick Century Radio Wiring Diagram

How to Wire a Radio to a Buick Century

Step 1: Gather Your Materials

You will need the following materials to wire a radio to a Buick Century:

• A new car stereo
• A wiring harness adapter
• Electrical tape
• A screwdriver
• A pair of wire cutters

Step 2: Remove the Old Radio

Before you can install the new radio, you will need to remove the old one. To do this, follow these steps:

1. Turn off the car and remove the keys from the ignition.
2. Locate the two screws that hold the radio in place and remove them.
3. Pull the radio out of the dash.
4. Disconnect the wiring harness from the back of the radio.

Step 3: Install the Wiring Harness Adapter

The wiring harness adapter will allow you to connect the new radio to the car's electrical system. To install the adapter, follow these steps:

1. Connect the adapter to the wiring harness that was disconnected from the old radio.
2. Use electrical tape to secure the connection.

Step 4: Install the New Radio

Now that the wiring harness adapter is installed, you can install the new radio. To do this, follow these steps:

1. Slide the new radio into the dash.
2. Secure the radio with the two screws that you removed earlier.
3. Connect the wiring harness to the back of the radio.
4. Turn on the car and test the radio to make sure it is working properly.